Ressichem Paint Guard 10,000 C

Paint Guard 10,000 C is cement-based waterproof thin applied plaster which is ideal for use on concrete / Plastered walls and ceilings. It fills fine pores of plaster and concrete and provides a smooth and dry surface essential for painting. Paint Guard 10,000 C is an ideal putty to be used in combination with Ressi PlastoRend 120, Insulaster or any other plaster material by Ressichem Prior to finishing it for paint. Paint Guard 10,000 C is suitable for many mineral based backgrounds and plasters as well prior to the application of paint and wallpaper.

ADVANTAGES

• Better adhesion and durability compared to other putties.
• Applicable on both internal and external surfaces.
• No curing is required.
• Water-resistant, application on moist surfaces possible (2 Coat application).
• Smooth Finish.
• Any type of paint or distemper can be applied on Paint Guard 10,000 C.
• No primer is required prior to application.
• Helps in preventing the growth of algae and fungus on walls.
• Premixed material; just add water

SURFACE PREPARATION 

Remove all loose particles, dust, oil, grease, and any other material which may result in poor adhesion from the substrate. The surface required for the application of Paint Guard 10,000 C is usually a concrete leveled surface or a leveled plastered surface.

PRODUCT PREPARATION 

it is important that water is premeasured in accordance with the amount of material used. Paint Guard 10,000 C should be added over the water to avoid the settlement of the material at the bottom of the mixing container. The mixing container should be uncontaminated, non-corrosive, and clean. Only potable water should be used for mixing.

APPLICATION 

Paint Guard 10,000 C is applied onto the prepared surface using a painter’s knife, Steel trowel, or appropriate tools used to achieve the desired thickness and finish of the product. Paint Guard 10,000 C is not a brush-applied material. It is recommended to build up the thickness of the putty layer by layer. The total thickness of one coat should be limited to no more than 2mm. Multiple coats can be applied.

TECHNICAL DATA

^{*Typical Results under laboratory conditions} 

CURING

No curing is required in general, however, if the temperature during application exceeds 40°C, curing for 48 hours is recommended.

SHELF LIFE

Expiration of Paint Guard 10,000 C is at 6 months after production date under dry and sheltered conditions.

PACKAGING

Paint Guard 10,000 C is available in 2 KG, 12 KG, and 15 KG Packs

HEALTH & SAFETY

Paint Guard 10,000 C is regarded as non-hazardous for transportation. Do not reuse bags or containers and dispose them of as per local rules and regulations. Gloves and suitable masks can be worn during application. Please refer to the MSDS of the product for further health and safety information.